“OP” if open; “SH” if short 55C Water Valve Press set Remove ice tray to collect water into a measuring container to measure water fill. Its wise to check the bottom of the ice tray for those cable ties holding the sensor to the tray once in a while. The test holes are identified as "N," "M," , "V," etc. note keep the old unit around for future tray replacement. Ice maker stopped working , ordered the solenoid for my make and model , installed it and it didn’t work , I ohm tested the old solenoid and it failed the test , so I ordered the ice maker it arrived in two days, installed it easy... plug and play great videos parts select !! Since the tray flex to pop out the ice cubes the ties well break again. Once the mold reaches the proper temperature, the ice maker starts a harvest cycle by ejecting the ice cubes and refilling with water. If collecting water into ice tray, first perform test 63C to empty ice tray. The part that makes the ice cubes is the evaporator so to speak, and has refrigerant flowing through it. (Make sure your test probes go into the test points 1/2".) Ordered new tray, simple install. Test points T & H … FZ display shows temperature sensed by Ice Maker Thermistor. If the ice maker is not working, the icemaker mold thermostat might be defective. TEST PROCEDURES Ice Maker Plugged In To Power Shut-Off Arm Down-Freezer Cold Test points L & N will verify 120 volts to Ice Maker module. The one upstairs has to be repaired because like I was saying, it's part of your sealed system. Inside the control module of the ice maker is a thermostat which monitors the temperature of the ice mold (ice tray). The flex tray ice maker is in the freezer section.
2020 frigidaire flex tray ice maker test